Search models, users, collections, and posts
Bio
havent printed or designed anything for alot of years. I got the urge to get a Bambu Labs X1C and im loving it so far.
Share
0
0
0
1st attempt at publishing a design. Work in progress try it out if you use a warehouse rack as a desk.
Friction Fit Multi Directional Light Mounting Kit
0
1
Share
0
0
0
these are awesome! re usable and keeps my filament controlled!
Share
0
0
0
Share
0
0
0
printed well, very sticky when pulling out the moving jaw! awesome for measuring on the go!
Share
0
0
0
good looking print. I think it might be too tight for my calipers and likely not to get accurate enough measurements as intended.
Share
0
0
0
Share
0
0
0
beautiful print, fits perfectly in the center of the spool!
Share
0
0
0
I wish I would have had this when I took apart the ams Junctiok box the other day.
Share
0
0
0
printed beautifully. Finally a place to put the poop!
Share
0
0
0
Great print! Thank you. my printer was able to get to the tightest tolerance. only slightly needed to pry it loose with a little pressure. great way to get a gauge on how the printer is operating.
Share
0
0
0
printed excellently. The detail is crazy good. the caps that are on top of the holders have clear indications on how they work and how to get them in place.
Share
0
0
0
Awesome design. My printer detected spagetti near the end of the print which might have cause misalignment with one of the parts. rounded out a screw trying to get it straight. I might be able to extract it and get it looking perfect overall awesome print! thank you!
Share
0
0
0
Share
0
0
0
No more data