don’t use PLA! PETG is the way to go! still using it to this day!

no notes! thank you for all the hard work you do for the community

a tad loose but with a little super glue, works a treat!

about as good as any calibration cube

I used this for my printed roses for Valentine’s Day. just tripled it up and connected them in Bambu studio and BAM! perfect

I used these for Valentine’s Day to hold my printed roses. everyone loved it! well done

it is very… loud when installed on the h2D. the long dowel type connects make a lot of noise. as for functionality? 10/10! well executed

the pic says it all! you just have to work a bit on removing EVERY HINT of supports for it to glue together seamlessly

print quality was great but the usefulness of the print when managing 2 different rental properties is a bit lacking. this is really meant as a set and forget type print. all in all, fantastic idea and execution

a little smaller than I imagined but works exactly as expected

absolutely perfect! no notes

worked exactly as designed! I was able to find out the perfect setting for my PETG support interface. THANKYOU!

came out decent. just don’t use silk PLA. especially from CookieCAD. supports failed twice and the layer adhesion is pretty crap. Also, take the model in Bambu Studio and modify the supports.

this is amazing! my bestie and I use these everyday! I printed his in orange and white while mine is in black and white

haven’t installed it yet but print came out great!

fantastic print and wonderful way of displaying QR codes

turned out wonderful! and I’ve noticed a difference over the last week of using it :)

I FINALLY finished the print! as always, your products are spot on! thank you for all the work you put into your profiles and CAD work. You are genuinely talented :)