Search models, users, collections, and posts
Bio
I started 3D printing and messing with 3D designs since the spring of 2025. I don't do a lot of designing so I still have a lot to learn, but I'm getting there.
Achievements
MakerWorld Guardian
This badge has expired
The post is no longer available
It printed great and was easy to assemble, though the little toe beans were a bit tricky due to their size. Tweezers helped a lot with the tiny toes. Went great with my other Eevee prints!
Share
0
0
0
The post is no longer available
The post is no longer available
Printed cleanly and went together very well, one of the teeth are a bit weird, but I probably got them switched up a bit.
Share
0
0
0
Printing the border separately worked great, added some super glue and it all went together great! I printed it for 1000 piece puzzles so there were quite a few pieces to print and put together.
Share
0
0
0
My wife was interested in a kitchen utensil holder on amazon that was in the shape of a coffin, but also a pink plain one with pink utensils. I bought her the pink ones and decided to print the utensil holder in the shape of a coffin so she'd hav ethe best of both. I then decided to add a more presonal touch by adding the image of Jack and Sally on it since we both really like halloween and "spooky" stuff.
Coffin Utensil Holder
14
36
Share
0
0
0
I had to adjust the size a bit for the around the corner bit and the 180 bit in the description, but they’re uploaded from another user and the print profile might’ve changed. The case turned out great though, I printed two as Christmas gifts and I’m sure they’ll love them!
Share
0
0
0
I cut the arms and BMO on the side from another print in the slicer and glued them on too. It looks good without them but I felt like it significantly improved it. I’ll try uploading the profile later when I get the chance.
Share
0
0
0
It printed great, stringing was a lot inside of it for a new roll, but I don’t have a filament dryer yet and I’ll never see it so it’s not a big issue.
Share
0
0
0
It turned out great! I colored in the eyes which bled through a bit, but the print model was perfect.
Share
0
0
0
This turned out great! I printed it single color and used acrylic markers to prevent all the purging, but it still looks awesome!
Share
0
0
0
It printed great, though I accidentally had flush to infill on and the black is showing through. Next time I’ll try laying them sideways to reduce how much waste there is to worry about.
Share
0
0
0
It printed great, the echo dot 3 I have fit snugly but didn’t require any force to go in! Make sure support settings are good, the ones under the legs especially can be hard to get off if they’re not.
Share
0
0
0
I added 19.3mm negative cylinders to the thinner profile to fit 3/4 inch wooden dowels. It printed great and fit the wooden dowels with a snug fit! I did 3 foot rods with this printed on each end and in the middle for extra support. With a snug fit the middle one needed hit down the rod a bit.
Share
0
0
0
It printed out perfectly, and I’ve already gotten several compliments and others asking for it for themselves!
Share
0
0
0
It printed great, I increased the lid to 100.3% based on another review and it has a snug fit, but not too tight!
Share
0
0
0
It printed great, though the red connection square for the red sword and red rods for the yellow sword were a little big, I cut them a bit and they fit better after that. Also the gray sword would do better with support on the connection end, but even without it I only needed to slightly clean it up.
Share
0
0
0
No more data