Printed great. Went with my lad to Comic Con

Printed great. I scaled them up to 128% to sort of match my duckies. They (and their reinduck friends) are going to be very nice little give-aways for the kids at school.

Absolutley fantastic. We have had so many compliments about the costume. Designer is also a very helpful person. Printed perfectly and assembled easily.

Printed great. There were a couple of strings but that was my filament probably not being quite dry enough. They fit perfectly, just slide on and snap into place. A secure fit but not difficult to remove. I can see these being really useful.

This thing is ridiculously long :) My son is very happy with it. TBH I'm happy with it. No fault of the model but it took me 3 attempts to finish. I'm new to enclosed printers. 1st attempt had 3 or 4 segments pop off the build plate a couple of hours into the print. 2nd attempt. I washed the build plate, took the lid off the printer and turned off the exhaust fan as I figured it was uneven cooling? I'd also been watching Functional Print Friday on the tube. I lost 1 segment a couple of hours in. Every lost segment had been from the the left hand side of the build plate, so I figured Aux fan? 3rd go worked. I had upped the build plate temp from 55°c to 58°c, turned aux fan down to 10%, turned the exhaust fan off and left the lid on. The printer chamber did get up to 43°c during the print but all went OK. The room my printer is is about 20 to 22 °c.

Printed pefrectly. Fitted well and works as expected.