Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 111 different models and 513 hours
love it! only issue I had was that the screw holes were a bit difficult to get a drill in, needed to create a drill bit extension chain but otherwise it’s been holding up strong
Share
0
0
0
Share
0
0
0
came out perfectly. exactly what I was looking for. thanks!
Share
0
0
0
such a cool idea. printed it in Bambu matte grey and it turned out great. one thing to note is that the clips are very brittle when printed in matte, at least in my case they were. so I printed the clips in regular black PLA and they worked fine.
one of them must have pushed through the layer above though, because it was loose when assembling.
overall though, I love it!
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
was trying to figure out a way to mount this, your idea is great! thanks
Share
0
0
0
Share
0
0
0
Share
0
0
0
printed 4 of these and they work great. one improvement could be using a different locking mechanism to avoid them from moving up and down when removing the battery. I printed some locks to hold it in place
Share
0
0
0
these stay on mine, but they weren’t tight at all and if you brush past them they’ll fall off. I’d recommend the 14.0mm
Share
0
0
0
works well, but had a few layers peel off while using it. could probably use a stronger lip
Share
0
0
0
Share
0
0
0
printed 2 of these, they work great. wish the smaller hook could fit more but I guess structurally it can’t
Share
0
0
0
works great! I only printed 2 of the extensions but there’s no leaning or anything even with heavier rolls
Share
0
0
0