I wanted to improve airflow in my Sharkoon VK2 pc case. Fresh air sucked in from the front of the case would get blown out of the top with a fan or even no fan installed in the front slot of the top of the case. This simple print prevents fresh, cold air not reaching the CPU cooler.

Oof, my ScrubMommy kept falling in the sink so I found a way to hang her by her eyes! B-)

Damn, the A1s power switch LED is so bright it lights up my whole bed. This cover I found would do the job but I'd definitely lose the flap in an instant... Maybe I could remix this so that the flap is hinged? Let me see.... There it is! I even put a little knob on the flap :-)

Oh no, my cat left me a special gift in my subwoofer! She was done playing with her catch of the day, it was a sweet little mouse who eventually found its way into the speaker port. I had to buy a new Subwoofer and wanted to prevent that from ever happening again! :-D

I needed a sequential shifter for my simrig and wanted to create something similar to amstudios seen in "MAKE THIS SEQUENTIAL SHIFTER USB" on YT. To turn the generic arcade joystick into a 2-way joystick I created this gate which has to be lowest part of the stick itself just like in the pictures. Have fun.

This replaces the original rear fender on a Husqvarna Vitpilen / Svartpilen 401 2018-2020. In order to be able to use this the rear indicators have to be repositioned to the underside of the seat. When using this license plate holder the license plate acts as the rear fender. mounting this is pretty easy, just find some fitting hardware, then place strips of double sided adhesives to the side which mounts to the original plate holder arm. Use original hardware threaded into the plastic.

Every leg needs a foot. In order to drop the Ikea Dagotto foot rest for my already low computer setup I needed some little feet to stick under one of the metal pipes. Just remove the bent pipe in the front and stick on these feet. Of course 2 need to be printed for one Dagotto.