Gaxej___

Martin Kozak

<p>Check my other slinky model: <a target="_blank" href="https://makerworld.com/en/models/93827#profileId-100425" rel="nofollow noopener">slinky christmas tree</a></p><figure class="image"></figure><p>&nbsp;</p><p><strong>Proper print parameters are crucial, it is recommended to use provided Designer's print profile!</strong></p><p>&nbsp;</p><h3>Print parameters</h3><p>0.15 mm layer height, 0.97 flow rate, 90 mm outer wall/inner wall/internal solid infill speed, lot of cooling. Use modifier to add more weight to the base (for example use more perimeters for first 3 mm). Ignore warning about “floating cantilever”. PLA works fine.</p><h3>Postproduction</h3><p>Use sharp knife or spatula to separate individual layers of spring apart. Be careful not to cut yourself. Glue in eyes, nose, mouth and hat.</p><figure class="media"><div data-oembed-url="https://www.youtube.com/watch?v=KqatZ1XZKuE&ab_channel=MartinKoz%C3%A1k"><div style="position: relative; padding-bottom: 100%; height: 0; padding-bottom: 56.2493%;"><iframe src="https://www.youtube.com/embed/KqatZ1XZKuE" style="position: absolute; width: 100%; height: 100%; top: 0; left: 0;" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen=""></iframe></div></div></figure><h3>Note on the filament</h3><p>If you have trouble separating layers apart, please try different filament. The one on the picture needs to be separate using knife, but I have different PLA and this can be break free with bare hands only.</p>

Slinky snowman

Nice

Alexis_

Ball Christmas Ornament 13

New Year

BillCosby

<p>Just a mount i made for xr10 axles uses a rubber pad and 150mm long velcro lipo battery strap i sell them if you want ot contact me. Or source your own. Mount is 95A tpu 60 percent infill</p>

Axial XR10 Battery mount

Axial