Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
I needed a ram mount to move my fish finder to a better location, and didn't have a track mount ram mount, but I did have an extra YakAttack rod base. I designed this to fit inside the rod base and use the base's t-bolt. The only thing needed is a 1/4'x20 nut, which in embedded in the print. I made a smooth and fuzzy version, and they both are holding well.
1" Ram Mount for YakAttack Kayak Rod Base
3
3
Share
0
0
0
I had tried a set of risers published by a fellow maker, but due to manufacturing differences between their kayak/seat and mine, I couldn't get my seat to work with their model. I decided to design my own set that is retained in place by the bungees installed on the kayak and has some extra strength for my extra size :). I tried these risers in TPU, but didn't like how much the rear risers crushed under my weight when resting, so I made these in out of PETG and they are working great so far.
2" Risers for Perception Outlaw Kayak
0
1
Share
0
0
0
I needed a simple way to mount my fish finder on my kayak's T-track. I already had a 1" Ram mount arm, but I needed a sturdy base to mount it to. I had an extra YakAttack rod holder base, so I made this simple piece to fit it. I embedded a nut, so it's super easy to install, with no tools or loose hardware.
1" Ram Mount for YakAttack Kayak Rod Base
3
3
Share
0
0
0
Works perfect! Printed in clear PETG with no modifications. Used to raise my hub to make room for an exhaust vent.
Share
0
0
0
I like the v6.3 version but wanted to print in ASA. The first attempt would not fit in the duct, so I tried again at 99% scale and it fit perfectly. Thanks for your work on this design!
Share
0
0
0
Finally, an easy way to get the full extension on these drawers! The profile worked great. I printed in white PETG for five drawers and each one worked perfectly.
Share
0
0
0
Great design. Scaled down 75% on the z-axis to fit my samples, and it worked perfectly!
Share
0
0
0
Share
0
0
0
I love this model. I did extend the chain a little so it would sit higher, but otherwise printed as posted in black PETG. I found it impossible to get the closers the engage until I reamed out the part where the chain is pinched in, then they easily went in. it must have been causing just enough tension to prevent the sides from sitting tight enough together.
I tried using it without a tennis ball, but it lost about half its bouyancy, so I put one in, and it’s been floating high!
Share
0
0
0
Printed in PLA basic. Easy to install and move. I first installed in the designer’s recommended location, but adjusted to fit my machine.
Share
0
0
0
Super easy to use for my Roku surround speakers. printed in PLA Tough+
Share
0
0
0
I wanted to use a side mounted spool on my P1S but had printer a lighted, vented riser and couldn't get the original or remixes to fit properly.
P1S Side Spool Holder for Vented Top Glass Riser
5
6
Share
0
0
0
works great and fits together perfectly! the venting is a great feature and I really like how the recommended led strip fits the circle exactly, so I can tell a lot of thought went into this build. I used Bambu PLA Tough+ black with no modifications. and bought the light in 6500k temperature from Amazon.
Share
0
0
0
No more data