These cane out fantastic even with a 0.4mm nozzle. I'm going to print a collection of each and put them in the jar and to make my own cap stash.

Excellent model. No issues printing in multicolor and printing three at a time. If I reprint it, I'll probably use a 0.2 mm nozzle for finer details.

eSun bone white PLA for the skull

eSun bone white PLA

Done in silver silk pla+

Made with some two tone filament I wanted to test out. Prints great even sized up like I did.

I did solid green on the eyes as I only had 3 colors in my AMS at the time. Instant top 10 print. Prints beautifully.

Fit two damaged spools from different brands perfectly. They both run smoothly in my AMS 2 Pro.

Apparently someone was jealous that I wasn't taking a picture of him. The supports are a challenge to remove because they connect to some of the ventricles, but the finished product is totally worth the effort.

I wish there were more discworld themed models on here.

I made his eyes green and added orange to his ears to give him a little bit of flair. I worked out wonderfully. Very minimal supports, very easy to remove. This one exceeded my expectations.

I resized the print, and went a bit too small. they basically look like mini chocolate chips. However, they work excellent as skull eyes. This skelly definitely has poop for brains.

holds the camera beautifully, doesn't require any additional hardware.

I made it bigger and slightly thicker in case it fell off the wall, it turned out beautifully.

I printed it in BL shiny red PLA+.

I told my SO that these were not a leak proof design, because I didn't have the TPU you need to make a leak proof cap. They didn't hear the part about not being leal proof so they snapped it on and turned the can upside down and spilled a bit of their sparkling water. This deserves 6/5 stars just for that moment alone.