Just wanted a nice way to keep this mushroom coffee and its accessories organized. Please boost this model if you feel like being nice.

Use 1/8th inch thick rubber stip for feet to prevent sliding, Holds your Elektron gear at a nice fairly upright angle while remaining stable on the desk. Prints without supports just fine.

These are a pair of rack ears to rack mount a model D synth. I included 4 small holes on the right side that you can plug 3.5mm cables into for storage. also there is a larger hole on each side, on the left it allows for USB to pass through behind the rack, on the righ its so you can feed CV or audio cables to the back of the rack. very useful to keep things clean. I do no support Beh, buy their gear used if you must buy it at all. prints in about 2 hours on a bambu p1s.

this stand prints at a nice tight tolerance that clips right on. place the stand so the feet slip into the groove.

Holds standard ¼" cables as well as usb etc just glue the two parts together , prints easily on a bambu p1s . screws in right where the standard Hydrasynth Deluxe shelf would normally go. enjoy! Seems plenty sturdy with PLA but I also included a PETG print.

use this to stop gear from bumping into the power switch of your Hydrasynth explorer! born out of necessity

just a cable holder for eurorack patch cables. command hook style adhesive or double stick tape it to where ever makes you happy.

Office chairs with roller blade wheels usually don't have locks. well I needed mine to stop rolling when using with my racing wheel. so I made this. fits the standard 75mm or so rollerblade wheel used in office chairs. print at 20-25% infill and it should be plenty strong. I actually did it at draft quality and it worked fine too. meant for use on small pile carpet. you might wanna add rubber to the botton if on hardwood floor.

I have had this idea for years but only recently did I finally get a 3d printer. this was one of the first ideas I decided to model up. It ran through about 8 revisions before landing on this design here. lots of little features in it to make it nice and useful. works great for Z rail eurorack systems. M3 8mm screws work best. 6mm are ok if the eurorack panel is not especially thick but I prefer 8mm. prints 4 in only 25 minutes on a p1s. gotta love it. pictures are from my longer lk5 pro print