Fangflyer

Sevro

Update24.01.2024v.1.3 More fitting base28.12.2023v.1.1 I fixed most of internal artifacts.v.1.2 I added alternative version of calendar with signs carved in monolith. You can colored it from top using "change filament" option so AMS is no required. Rest of pieces fit to it. You can use ironing if you want more fine finish. However I still recommend original version.&nbsp;<figure class="image image_resized" style="width:63.61%;"><img src="https://makerworld.bblmw.com/makerworld/draft/447100/2023-12-28_2f17c0b9f0ee9.jpg"></figure>&nbsp;OverviewMy adaptation of cryptic calendar for 3d print. Original project you can find on on youtube.<figure class="media"><div data-oembed-url="https://www.youtube.com/watch?v=gMqPtWCNr_E"><div style="position: relative; padding-bottom: 100%; height: 0; padding-bottom: 56.2493%;"><iframe src="https://www.youtube.com/embed/gMqPtWCNr_E" style="position: absolute; width: 100%; height: 100%; top: 0; left: 0;" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen=""></iframe></div></div></figure>&nbsp;InstructionMonoliths are colored from bottom so you can get additional effect from various textured plates. AMS is quite helpful in this case.Bases you can also print on textured plate and upside down it for textured effect.You can use one base or two as you need. If you use two, put one i anotherThe indicator for months has an upper and lower side. Place it on the monolith with the dot side down. The dot is shown below&nbsp;<figure class="image image_resized" style="width:39.51%;"><img src="https://makerworld.bblmw.com/makerworld/draft/447100/2023-12-27_c9914aaf89a6f.png"></figure>Have fun

Monolith Cryptic Calendar

fun stuff

Brandido02

A honeycomb wall mount for the AMS.this is compatible with Honeycomb storage wall accessories.Make sure you secure it to the wall properly with wall anchors.10/8/23 Uploaded new stl files and a new Bambu 3mf project.

AMS Hex Wall mount

Useful stuff

Linuxx

This is the arms for the spice rack I created. I used 3/8" wooden dowel from Lowes. Cut the dowel to length and mount using 3M command strips.Printed on the Monoprice Maker Select Plus using Cura at 0.2, brim, with 15 infill.The large version if for spice containers that are wider, although are the same height. I haven't tested them, so use with caution. This version may need stronger adhesion to the cabinet / door.

fun stuff

Useful stuff

Alyx’s Kitchen Adventures