The print itself is flawless as ever with Poke Prints stuff. I am a tad confused what this black puck is for in the print profile, but that could be my bad😆

My favorite pokeball that has been made by Gamefreak. is there anyway you can fix the gaps on the back or front? Thank you again! Edit: N3d's pokeball got me confused. Pokeprints has the more accurate design here🥳

It looks so good! had a bit of a had time getting the button part of the ball together. All that you need to do is glue the ring and the button on the bottom half first. At least, that is what helped me😆😅.

Absolutely stunning! Great work as always Poke Prints.

One of my favorite he has ever done! It would be nice if there was a easier way to get the "fins" into the main part, even a little more tolerance would do😅. It looks so good though!

Once again the pokeballs look great. All the parts printed fairly well but can be a little tricky to glue in especially if the super glue sticks to your fingers. I would totally give this four and a half Stars if I could just because every once in a while the horn or something else wouldn't stick properly even though I clean the bed. that kind of stuff happens sometimes though great model

The ditto printed amazing and I even scaled it up a whole bunch to fit an A1 Mini print bed. Now it adorns my Pokemon ball collection

It printed an assembled pretty good. The only issue I ran into was that the pokeball bottom was upside down in A1 profile and I had to fix that in bamboo slicer. Is there any way maybe to make the yellow band a little bit thicker? I think a few more millimeters would make this even more stunning! Love your work!

Look amazing! Good job pokeprints!

It's really cute, I hope you do Galvantula or Joltik some time. I don't got TikTok to request it there😅.

Printed and fits together nicely

Fits together quite nicely! I may scale it bigger

It works and makes me feel like a goofy menace 😆

Printed in PLA, this folded good! I waited for the plate to cool and it folded no issues. I may test the P1S version and cube one too!

The print holds the controller really nicely, assembled quick, and my lady loves it!

I had to reprint one of the side grips after the supports messed one of the sides up, but it printed so beautiful after that! Great work!

Love this model and love the logo. This helped finish my Mega A1 Mini😄

I wish the print connected better to the back of the Mini itself, but it does a good job! This is a great design!

I printed parts on both the P1s and the A1 mini. I only has 1 hickup that I caught when the Mini was printing the back for the filament roll where it didnt connect the parts. Slicer error when the A1 Mini downloaded, not an issue with the model.😆