Emiliobot

Michal

A compact poop container (S - small version) designed for the Bambu Lab A1 and A1 mini printer. Very easy to attach and remove from the printer.A larger version of the basket is available at this link: <a target="_blank" href="https://makerworld.com/en/models/501368#profileId-416430" rel="nofollow noopener">https://makerworld.com/en/models/501368#profileId-416430</a>&nbsp;UPGRADE 19.06.2024According to your comments, I made the following changes: 1. Yellow arrows - latches have been added to prevent the basket from sliding during vibrations. 2. Red arrow - the shelf on which poop was sticking has been removed. 3. Green arrow - the wall has been raised to further protect the poop from falling out. 4. The height of the basket has been increased by 5mm to increase its volume.5. To make the basket quieter, you can cut a thin sponge and stick it to the bottom from the inside.&nbsp;<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/model/DSM00000000451897/design/2024-06-19_7865e4dc0924e.jpg"></figure>

Compact poop bucket S (A1, A1 mini)

A1 Mini

Joe Wilson

this is based off my other mini saber here <a target="_blank" href="https://makerworld.com/en/models/142757#profileId-155277" rel="nofollow noopener">https://makerworld.com/en/models/142757#profileId-155277</a>this one however has a removeable cap so you can swap out the blades to have a different colour.&nbsp;PRINTINGprint the blades upside down with tiny bit of supports for the middle piece0.2 layer height for the main case and capcan be up to .28 layer height for blades&nbsp;

Mini Saber Seperate blades, extendable light saber

davidpyo

This is a progressive BCAR similar to Andromeda. It begins at a 10 degree tilt and ends in a 30 degree tilt. Intended for high fps blasters and 16mm OD barrels. Two end caps are included, if the original is too loose when tightened, use the other. Requires 9 F683zz bearings, and 9 M3 bolts of at least 8mm is recommended. The flanged side is closest to the print or furthest away from the bolt head. Print settings are .2 mm or lower layer height, no supports needed. Print orientation shown in the photos. Update 2/20/2024:Adjusted thread size, barrel tolerance, and durability. Released V2, which is incompatible with the original threading. &nbsp;Update 2/27/2024Added Lynx 2.1 version (I think backwards compatible with older version but unconfirmed)Added EX compatible version

Triangulum Progressive BCAR

Nerf

SabreDesign

Inspired by several other designs, increased capacity on my design and tweaked some things. Bucket protrudes 50mm behind the printer.Printed in Bambu PLA with 2 perimeters (took 4hrs on X1C, standard settings)Designed for some 6x1mm magnets I had laying around, design can be easily adjusted, included .step and .f3d files.

A1 Mini

Fun

Nerf

X1C