Could be added different sizes

model is good, works good but I didn't understand why there is 3 of them.

Great on the paper but execution needs improvements. needs a lot of work in the design.

Its sooo good.

good model.

works good.

Very nice. there is 2 extra ones in the plate. you could design them in a way that they will be print in place so we wont have to insert a bunch of filament cuts to assemble them.

Great model.

fast and works.

Great. If you make the ends just 1 mm slimmer it would fit to hub also

Cute, as expected. you can set to purge multiplier to 0.8 and it will still look good tho but it will take less time.

Great, however you could optimize the print setting to make it around 90 grams lighter, especially in this application where motor are alreadyt working close to their limit that would make a significant difference.

Loved it!!

Model is great however the print profile needs a lot of edjustments, here are all the issues I found in the print profile and solutions: 1) feets are prone to breaking, increase the wall count to 4 on the feets and use gyroid infill. 2) body is prone to break, increade the wall count to 5 and use 25 percent gyroid infill. 3) head is unnecessarily heavy, decrease the wall count to 2 and use 15 percent gyroid infill. 4) hole on the head for the beak has supports in it, using the support painting ensure there would be no supports in this hole. Also model can be adjusted to give slightly more vertical clearance for the beak to compensate for removal of supports. 5) during printing front facing parts of the eyes are towards the build plate and that causes some very looking eyes when assembled, turn the eyes upside down on the build plate so better looking parts would be visible. Or better split each eye into 2 pieces horizontally and print them seperately then assemble the eyes.

Great model, I directed the air out of my house with air conditioning hole on the wall, results are very good. the parts used in this project are very specific, maybe in a future project your could design something for more main stream parts.

Great model, super durable, end of the handle tends to lift off the plate but print completed succesfully.

Great model but print orientation of the parts are not good, they cause a lot of articats.

I loved it, It was so funny that I had to print also The Pink Panther to go with it. model is great but for the body adaptive cubic infill would be better.

Small parctical, can be slightly bigger so a wood screw can go through the hole without ripping model apart.

Very good model, historically accurate