very clean print. I did make some changes prior to printing; 1) used Arachne wall generator instead of classic 2) order of walls swapped to inner/outter/inner 3) went up to 3 wall loops 4) sparse infill used 8% Gyroid 5) Supports -> tree slim, supporting critical regions only. printed using Rosewood Bambu Wood PLA.

The Print profile for this is 5 stars. It prints flawlessly, with no issues. However I have other issues related to the functionality/design of the model itself. Since printing out a large batch of these and using them as indicated in the description and photos. I have had 3 separate instances, where my AMS has jammed up, because the loose clip getting stuck and pinning against the spool, or tangling in the filament, during multi-colour prints. I will say any prints I have done where the print is single colour, I have not had the issue occur. TL;DR print profile and model itself print out great, and are well designed. Issue, is that the functionality of the model in the use of leaving the clip loose fitting when fed into AMS can cause some issues.

Printed out 4 of these so far, and all have been great. Fast print. Only thing is I wish that the area for the small clear Bambu tag you apply when swapping out the refill on the spool, was solid, so that the text on the small sticker was easier to read.