Search models, users, collections, and posts
Bio
NEW BATTLEBOT DESIGN OUT NOW!
https://makerworld.com/en/models/2778874-slice-of-nice-antweight-battlebot-wedge-1lb#profileId-3088003
I'm a Christian that got a bambu P1S printer, and uses FreeCad to make all my models. I design a little of everything, but I mainly want to get into antweight battlebots, Baligsong/Butterfly Knives, and fingerboard accessories and ramps.
Pancakes are da best breakfast in the world. What else is there to know?
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 110 different models and 633 hours
First off, I'm no expert balisongist. I learnt on 3d printed butterfly knives/balisongs and never touched a trainer that wasn't under $50. This is the best trainer i've held yet. I've printed around 8 other butterfly knife designs that compared to this one were all just terrible.
I ended up putting three 177. calibar lead pellets in each handle and put four of your standard BBs in the 'blade'. It's the only trainer that i can do a chaplin on reliably. My friend got an >20$ amazon metal trainer and honestly I prefer my 3d printed one. The one thing I changed was the pins for the blade. I printed them on their sides because printers print stronger on the x and y plains then the z plane.
Probably the best balisong knife design on Makerworld, unless the creator makes a newer design, I'm never printing a different balisong.
GIF
Share
0
0
0
THIS ILLUSION IS PERFECT! Everyone who didn't give this five stars is 'Seriously Mistaken' you have to look at it from a very specific angle. Everybody is looking at it wrong. This is actually so cool. This only has 3.5 stars bc people don't spend enough time actually trying to figure out how it works. 10/10. WILL BE BOOSTING once i earn anotehr boost token! I'll upload a vid of how it should be positioned!
GIF
Share
0
0
0
Hey, i have made a skate park for tech decks, but there are multiple pieces that clip together. Should I post it all as one skatepark with lots of different plates or each as separate pieces and put links for all the other builds?
Share
0
3
0
Use it for grinding with my tech deck. Its a good idea to put anti slip pads on the bottom tho.
Share
0
0
0
really nice, fun design. I scaled down to 80% it had some problems and was hard to break into to make smooth. Just don't scale down :)
Share
0
0
0
Lol, my mom doesn't think my 3d printer is useless now!
Share
0
0
0
My mom loved this lol.
Share
0
0
0
Nice, Really smooth. I should've made it a bit bigger
Share
0
0
0
work great for feeding tarantulas Mealworms.
Share
0
0
0
Perfect. Used it for my tarantula
Share
0
0
0
Noice! breaks easily though.
Share
0
0
0
Share
0
0
0
Really nice spool! Kinda dissappointed there isn't a place to put the sticker tho
Share
1
0
0
Nice and smooth!
Share
0
0
0
Share
0
0
0
It's a fun spinner. A little boring once you do it for 15 minutes
Share
0
0
0
Share
0
0
0
The was BUTTERY SMOOTH when i first printed it! Sadly I dropped it on the ground and the inner ring isn't as smooth. It's the perfect size, and will probably print another in the future.
Share
0
0
0
Really nice action figure but really exessive stringing. I'm not sure if that's my or the models fault but good for stopmotion!
Share
0
0
0