Dream Builds

Clay

Remix to an awesome model by Josh-3d&nbsp;Scaled 150% to fit M5 Hardware and has a wider shelf.&nbsp; I have a 10 Air and it is totally solid while using

Industrial Ipad Stand - M5 Hardware

useful

user_1331173554

gear ratios: 17:1, 58:1, and 204:1

Tamiya 70093 3-Speed Crank-Axle Gearbox Kit

Yedoggie

After posing my V6 Engine Cooler, I had many people wanting a V8 Engine Block Cooler. This V8 cooler is sliced for P1 and X1 printers sonly. I labeled the plates for easy orientation during install and print. The duel color is set after slicing and I placed a color change in the file so it saves time in print and same across the board once you assemble. Change the color combo to your preference.Support is neededI only use support interface on the top lid. The rest was not needed and it saved time.&nbsp;Note: because I sliced it to build the cooler, I used a Gorilla rubber type glue to seal all the seams so it wont leak when you put Ice in it. Due to the very tight tolerance of the lid, I pre-shrunk it to 99.8 percent so its easier to put the lid on. For some reason it shows up as 100% after doing this, so if you want to put it back to original size, just put it 100.02% but it will be very tight.&nbsp;My V6 Version: <a target="_blank" href="https://makerworld.com/en/models/211857#profileId-231643" rel="nofollow noopener">https://makerworld.com/en/models/211857#profileId-231643</a>Koozie: <a target="_blank" href="https://makerworld.com/en/models/411911#profileId-313818" rel="nofollow noopener">https://makerworld.com/en/models/411911#profileId-313818</a>&nbsp;&nbsp;

useful

Rc

Decor