Very nice print. Very clean finish. Thank you. Support columns came right off with ease. Printed at 200%. Good size for a decorative peice.

niftly lil' thang! Thank you. Printed to finish my spool :) Supports came off very easily

Very nice design. Simple and effective. I had to flip the small part due to warning messages of a cantilever effect. Just one issues I seam to have missed it the thickness of the support groove. It's too thin for my screen. Make sure you measure your screen thickness and modify accordingly.

Very nice design! Just by chance my spool ran out over night at the exact half point. Happy to day it turned out great with the dual tone. The wife loves it! Thank you!

I don't have AMS. Printed the topography plate fine. however I had difficulties with the boarder frame. After my 4th attempt and trying virtually everything (drying the filament, leveling the bed, changing the nozzle, calibrating) Due to the terrace step on the frame, I had no contact when it switched to the next step.i solved this but mirroring the model in the Z axis. Worked like a charm! The model is great! Thank you!

Nice design and fits the board like a glove. I would try to make an iteration with less plastic on the sides. it's not needed. maybe integrate some hollow pattered. But I assume it'll need a lot of supports. These supports snapped right off with a very clean finish.

niffty little tag. thank you!

Both hollow and twist tops are great! Can add some glue to the twist tops as sometimes they might come undone. My only pet peeve is the hole. it's too small for a 550 paracord. I spent too much time trying to lace it. might suggest to increase the size by 5-10%. I added a 0.5 Brim for extra bed adhesion.