very cool design, looks neat. scaled the 5.5 version to 2x because I needed it for a small water line, still worked well and thread moved easily. highly recommended

nice design, printed well and brings order to what used to be a mess in my drawer. includes magnet holes (default 6x2) as well.

very nice, exactly what I needed, only magnet holes were a bit wide and their base was quite rouge.

great stuff, even comes with cavities for magnets on the bottom, default 6x2 mm gridfinity magnets fit press without glue. consider adding this info to your description, I always find it hard to tell from people's models which are with magnets and which aren't.

you are a hero, saved me so much money as kitchenaid does not sell this cheap plastic crap separately. Thank you so much for this!

looks fine, printed well, good size

looks very natural and printed well. The supports for the upper cave were a little tricky to remove but turned out well.

such a cool design, feels like a bought object and is so satisfying to use. Only issue I have is I don't see need for the tip, it keeps around 10 2x6mm magnets that can't be used

looks great, printed well. does unfortunately not fit 2 m braided cable, of which I have a lot. Would love to see a higher Version for those longer cables as I very much like the design

Printed well and works as intended, gave the thread a drop of glue to have everything tight and sturdy. The first of these cable winder designs that was able to hold a 2 m braided USB cable. I prefer some other design in terms of esthetics, but that's just my personal taste.

printed well, central winding piece is a little wobbly and the lid could fit a bit tighter, opens up by itself. I am testing through some of those cable winders, as none of them seem so fit a little thicker, 2 m braided USB cable. Does not quite fit here either, only with a lot of force which makes it inconvenient and threatens damaging cable or the part itself.

very neat design, printed well, been looking for something similar for quite some time, thanks for sharing.

This is so insanely helpful to reduce purge waste by a LOT. Took me some time to figure out how it prints correctly on my A1 though, BambuStudio rotated the infill by 45°, the setting for 0 is under advanced. I found that printing from handy app is the easiest, results were the same as from studio for me.

extended version is big enough to comfortably hold my AMS even with the famous covers mounted. printed perfectly in PETG.

sturdy construction, just what my homeoffice setup was lacking. recommend to add some rubber feet to prevent sliding on the desk.

masking cables with these is almost addictive. great design, prints well, great stuff.

Love these, make the enclosure even better not having to open it to check filament levels

Lots of work for the printer, but the result is way worth the time spent.