Printed perfectly

Printed in PETG. I enabled all supports and printed with infinite walls. I ended up leaving the bottom support on since it adds some stability to the clip part, which easily broke off when I printed it the first time with the default profile.

This print profile is probably fine for very lightweight things, but I think there are a couple improvement that can be made to this print profile for PETG. This allows it to be used for heavier accessories and last longer. 1. The threaded screw should be printed at 100% infill (set walls to 1000) and there should be a version without the hole on the bottom of the screw piece/rectangular base. This piece broke twice when I printed it at default and slightly higher infill values, though I was using some force to get it tight on a coldshoe. The part is just too small to not print it solid, and it only uses a few grams of filament to print it 100% solid. 2. The threaded screw should be printed at 0.12 mm layer height to make it easier to thread onto the triple coldshoe adapter piece.

Amazing idea and I boosted this, but I think if the top slid open it would make pouring in and removing dessicant much easier