Printed with Bambu PLA Matte Grey and [blue?] Glow filaments. Scaled the print up about 25% to fit my glassware. Couldn't be happier with the result; so I printed another to pretend that I use the waypoints to teleport my seltzers from the kitchen to my desk.

Printed it in PLA glow because I have a blacklight bulb for night time. Printed on the first try flawlessly. Snake took a bit to warm up to it, but he totally pushes it around. And it looks cool at night. A++ would print again.

i was somewhat skeptical of this type of printer mod because I've seen a disagreement between designers and engineers, but I am happy to report this print resolved a print adhesive issue specific to the lower left corner of the print bed. Printed in ABS at 50% speed. It did not take any force to install- just had to insert it at the correct angle and it popped right in. This specific print has been revised several times based on end user feedback, and for me, the results are measurable and night-and-day.

This is a "Bambu Essential" for me. This design snaps into the hub's ports perfectly and eliminates the need for you to jam a screwdriver or something into the hub to release a fillament tube. Printed in ABS with the Bambu Labs AMS defaults and it came out great.

I'm new to printing and could not figure out how to review this!! this print really motivated me to figure out how to rate because it's educational, easy to print, and great reference for newbies like me.

Love this thing. Zero hardware required. Intuitively pieces together. I fidget with this thing quite a bit and found the PLA to be a bit wiggly. I reprinted the "Red" pieces in ABS and would highly recommend.

this is amazing.