Search models, users, collections, and posts
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Stellar Reviewer
Rate or Comment 459 different models
Pioneer Maker
Print successful 440 different models and 733 hours
I like this print but kinda wish the front one had a bottom under it so bits didint fall through I used some eltrical tape and it worked good enough
Share
0
0
0
The post is no longer available
quick simple and works great
Share
0
0
0
amazing print and even had a cool little print pattern on the top
Share
0
0
0
simple and quick and just what I wanted!
Share
0
0
0
Share
0
0
0
prints perfect and I did it in PLA and seems fine but finally a bit holder that fits properly and holds bits tightly! I’ve tried 3-4 other prints and they where junk compared to this one.
Share
0
0
0
just wish it had a pin for the wheel but other then that perfect!
Share
0
0
0
way better then the over complicated other chapstick holders that always break, this one last!
Share
0
0
0
my dad loves it!
Share
0
0
0
The post is no longer available
amazing!! just like my real dog
Share
0
0
0
works great and clicks on good
Share
0
0
0
worked super good butttt if you have the snipper holder on the other side the both won’t fit on the p1s but they sit on the side of the shelf’s so it still works well!!
Share
0
0
0
10/10 easy fast print just open up the door peel the strip and add it to the tray, way better then throwing it in a box or the trash everytime
Share
0
0
0
No more data