Dead Phoenix Models

phillipjfry

<h3>Skeleton Finger Magnet and Keychain</h3>Profiles: 1. Keychain and magnet2. Magnet Only3. Keychain Only&nbsp;Printed in:Sunlu White PLA+Elegoo Black PLA+&nbsp;These are printed face up with ironing turned on. I use magnetic tape to stick these on the wall, but double sided tape should work. The key rings are from amazon.&nbsp;Hope you like my models, if you do please leave a rating and check my profile here: <a target="_blank" href="https://makerworld.com/en/@phillipjfry" rel="nofollow noopener">https://makerworld.com/en/@phillipjfry</a>Maybe <a target="_blank" href="https://www.buymeacoffee.com/phillipjfry" rel="nofollow noopener">buy me a coffee</a>, I go through lots of it, thanks.&nbsp;Have a great day and happy printing!!!

Skeleton Finger Wall Decal/Magnet and Keychain

cool stuff

suit1337

Spool Arm for side mounting the original spool holder It is designed to screw directly into the left support beam of the printer, for extra stability - other spool holders that float right next to the printer tend to sag quite a bit&nbsp;<h4>BOM</h4><ul><li>original spool holder</li><li>2 x Original spool holder mounting screws</li><li>2 x M3x8</li><li>1 x M3x12</li><li>optional: <a href="https://www.printables.com/de/model/456234-side-filament-guide-arm-for-p1p" rel="nofollow">Side Filament Guide Arm for P1P </a></li><li>optional: <a href="https://www.printables.com/de/model/438243" rel="nofollow">Spool Roller / Holder for Bambu Lab P1P</a></li></ul><h4>Printing</h4>i recommend 6 to 8 wall loops and a good amount of infill 30 to 40 % should doif you don't have any enclosure, you want to print the 5,5 mm spacer, with an enclosure with 3 mm wall thickness, you'll need the 2,5 mm spacer - measure and adjust for the actual size<h4>Assembly</h4><ol><li>Remove the original holder and save the screws</li><li>Screw in the spool arm in the back with 2 M3 x 8 Screws in the holes, where the original holder was mounted</li><li>put the M3x12 screw through the center hole and the spacer around and screw it into the left beam - the hole there is not tapped, so a firm press and slow, straigt and steady will cut threads into the thin metal beam (you also can use a tap, if you have one)</li><li>mount the spool holder with the 2 original screws to the arm</li></ol>NotesThe radius of the arm matches modplates with a maximum thickness of 3 mm - if you have thinner pieces, it might leave a small gap or might not fit at all on thicker piecesthe gap between the outside edge of your enclosure and the left beam of the printer frame should measure 5,5 mm (the provided spacer distance)if you're looking for a matching enclosure, the <a href="https://www.printables.com/de/model/381777" rel="nofollow">Minimal Enclosure</a> fits perfectlyif you want to utilize it the for the P1S, use a generous amount of infill - if you want to prevent sagging, you need to drill a small hole into the sidepanel to mount it into the frame &nbsp;&nbsp;<h4>Changelog</h4><ul><li>v18: the mount for the original spool holder has a second surplus counterbore which helps, when you want to mount it upside down (for the spool roller for example)</li></ul>

cool stuff

p1p stuff