larger than expected but good quality

a few straggly stringy bits but otherwise perfect. exactly what I was looking for

great quality, no issues with printing and work like a charm

came out very good, just some layering issues, however it was good enough for what I needed.

printed out first attempt no issues

printed in full yellow for my daughter to paint, came out brilliantly first try

thought they would be a bit flimsy when watching them print out, but very happy with the quality.

some stringing and a failed start on 1 of the prints, luckily I caught it, restarted but slowed down the first layer and all was fine

I cheekily asked the designer to do Elland Road for me, and hey presto... Great design, prints off lovely too.

barring an issue with one of the arms not printing properly, everything else was great with this cutesy Batman

had to put a brim on it to make it stop failing, but otherwise a lovely clean print

great add on

A gift from one daughter, nice bit of decor.

Fantastic little gift for our daughter's teacher. Printed really well, and had to use dual colour silk+ for the frame as I didn't have the appropriate colour.

Great little print for a gift for a board gamer. Had a slight issue with first layer, but caught it in time. Printed first couple of layers at 50% and it sorted it right out. I also didn't have enough black so went for a different colour, and I believe it turned out great.

Changed the font and that has somewhat made the print a little worse, however that is not the fault of the profile or the model, that was through my own stupidity. The model itself, didn't print correctly the first time on the first layer, so I ended up printing the first couple of layers at 50%, and it worked flawlessly.

A very nice piece to print, did take a while due to the colour changes, and I got a bit of infill flush bleed around the eyes, but otherwise great

had a failed set as one of the handles didn't adhere and knocked into the others, reprinted and all fine.

love the box, my only issue was when on the slicer, it told me things were clashing and to use the auto arrange, which took the latches off the lid and printed them seperately so they weren't attached at all 🤷🏻‍♂️

Another great print that the kids love, is there any extensions or alternative bits to make it longer or take a different route, as that would be fantastic?