Dawson_CZ

LP-E6 "Tri-Hold" battery case

Stand for cameras with Peak Design/Arca plates

Spartan Trifecta Medal Stand

Aputure MC honeycomb grid

15mm Rod Stand for Camera Rigs

15mm Rod Support for Camera Mounts

Works well with the recomended printed bearings. I tried printing a few models directly from the roller and it went pretty well.
Thinking about mounting a PTFE tube somehow, so the filament does not bend as much.

JediPieHut

The Ultimate Spool Roller for 608 bearings.

0.2mm layer, 3 walls, 10% infill

Printed fine without AMS. Eyes glued in, hope they stay 😁

Nismo3Dprint

Starfish articulated

no ams

Kumpelblase

IKEA 365 Spool Holder | Filament Storage | Drybox

Supports for Spool Holder: 0.2mm layer, 2 walls, 15% infill

I had a little dificulty snaping the 2 pieces together, but that is probably caused by the filament i used.

0.2mm layer, 3 walls, 15% infill