so it took me five times to get it right the sixth time I use Elmer's Glue on the board for some reason it kept coming loose

turned out great can't wait to mount it in the pool I did notice the support bracket was curling off of the table any suggestions why. pet G fill. any helpful hints to get rid of the lines or at least smooth them out a little better

so I have tried this four separate times and none of them have been a success three of them were spaghettis and one says it was successful but it was not completed I don't know what's going on if it's a printer issue or if it's a program issue but I have a bamboo A1 after the first 2 I stuck the filament in the microwave for 30 seconds 5 minutes off three times then I went to print and it finished before it actually finished with no spaghetti I'm not sure where I went wrong or what happened but any information is good information

everything turned out great kids love it

good job thanks for the print

everything turned out great even holds tablets

so I'm two for two and 0 with no complete success I don't know if it's my filament or the program I see a lot of success but every time I go to print this out something starts going on with the print like it's twisting here are some photos of the filament that I'm using it is brand new immediate level in my box is in its twenties they have been dried properly before printing maybe you can explain from your experience what I'm doing wrong and I printed this out in slow mode on a bamboo A1 I appreciate any information to anybody can give me thank you

overall it turned out good it was a little bit small for the straw I had to sand the inside a little bit but it did split it open and the supports really didn't do anything they were sticking out of the side instead of supporting the other part of the star

love the idea for my situation I even printed one half just so I had one to hold the wash towels thanks for the print

works well no complaints thanks for the print

turned out well I end up using double stick tape for mounting in an RV works perfect Blends right in can't even tell it's there printed it in transparent

everything turned out great but I did notice with printing with clear it didn't attach itself quite well no biggie I just added Super Glue everything worked out as expected appreciate the print

turned out better than I thought appreciate the print

turned out beautifully wonderful gifts to give someone

very clean look it's balanced perfectly flat completely happy with it thanks for the print there is one thing the 3D image that's on the app makes it look like it takes up the whole entire heat plate which it's a little smaller than I thought next time I have to go through slicer because from what I observe I thought it took up the whole entire plate if you have bigger ones that I would have to print up separately I would love to have those my daughter loves this thank you

nice work

everything turned out great I think the screws could do something different maybe with the threads not expecting it to be super tight of course it's plastic but they seem to just spin without much hesitation and not stop on most of them but very little pressure is needed when tightening it down before it overlaps itself

the quality turned out perfect I thought that they would be the same size with as the pegboard that I'm using for it they're a little shorter I'll figure out what to do next maybe it will look good I don't know but happy with it

everything turned out awesome