Daniel

kenkamm

This is the best side spool holder, I think. I hope I am correct. It features:<ul><li>Improved roller assembly that prevents the spool from riding off the roller</li><li>Better rigidity thanks to a stiffening rib</li><li>Simple installation and removal of roller if needed</li><li>Threads for a PC4-M10 fitting that holds the PTFE tube securely, so you can push on the filament as needed when loading</li><li>Clearance around the bearing inner races so they don’t rub and cause friction</li><li>It looks good. :)</li></ul>Parts needed for this installation:<ul><li>M3 screws for mounting the printed parts to the printer</li><li>PC4-M10 fitting<ul><li><a target="_blank" href="https://www.amazon.com/BIQU-Straight-Pneumatic-Connector-Extruder/dp/B01IB81IHG/ref=sr_1_4" rel="nofollow noopener">https://www.amazon.com/BIQU-Straight-Pneumatic-Connector-Extruder/dp/B01IB81IHG/ref=sr_1_4</a></li></ul></li><li>2 ball bearings<ul><li><a target="_blank" href="https://www.amazon.com/dp/B07R7PR72H" rel="nofollow noopener">https://www.amazon.com/dp/B07R7PR72H</a></li></ul></li><li>You will need to extend your PTFE tube, you can use this piece with two PC4-M10 fittings to extend your PTFE tube:<ul><li><a target="_blank" href="https://makerworld.com/en/models/89430#profileId-97228" rel="nofollow noopener">https://makerworld.com/en/models/89430#profileId-97228</a> </li></ul></li></ul>&nbsp;Please note: The spool roller uses variable layer height to achieve a clean print with the steep overhang angle at the top. This is critical for success in printing the roller properly. If you use your own settings and don’t want to use variable layer height, be sure to print the roller with .1mm layers.&nbsp;Also note: Please use the smooth sheet to print this. It may not have enough adhesion with the textured bed unless you add a healthy brim.&nbsp;No supports are required for the filament guide and the spool holder. The roller should be printed upright and supports should be enabled for the print bed only.&nbsp;The filament guide and spool holder should be printed with 100% infill to maximize rigidity. The roller can be printed almost any way you want (except for the note about layer height above) but my settings are a good starting point.&nbsp;I hope you like my spool holder. If you leave a comment below, and there is something you don’t like, please mention how you would improve it.&nbsp;Happy Printing!

The Best Side Spool Holder (IMO)

tools

BarnesStudioStore

Designed this portable TICTACTOE game for my kids and I to play on the go. you&#39;ll need to print 4 x&#39;s and o&#39;s and no supports, rafts or skirts are needed.&nbsp;Just print and play on the go! haver fun&nbsp;UPDATE: Cross bars to the bottom board have been fixed