I didn't get to use this one as it doesn't fit any tables I have. So pay attention to the size table you have before printing. It is a beautiful Design and it need more options for table sizes.

While this printed flawlessly it is really light and feels supper cheap. But printed in gold silk it look so nice. I think silk or translucent type filament would be best to get the sparkle.

Love this design and the ability to fit the cards and the instructions. I did my in recommended colors and ran out of green toward the end and used Neon... still looked amazing.

These hats were such a hit at Christmas Eve. I did have a few issues printing them at first. I didn't have my settings right and had to skip one of the prints. But the design and the way they work is great. Just be cautious of pulling them apart. My husband just grabbed the top of one and pulled holding the bottom. Not the way to do it. It got fully deformed. I did the slow spiral through the one break of the spring.

I did this is a gold silk filament and it came out so cute. I printed tow on a plate and one the foot separated when pulling off the supports so be careful. I used Gorilla Clear Grip Contact adhesive just a drop and a rubber band to put it back together. Just incase it happens to anyone else. It look flawless now. Great Job on this squirrel.

SO cute!!! Love the wobble once you break the pieces apart. So perfect.

I used PLA and broke a piece. I think a bit better directions on putting it together, I could not tell the difference in some of the pieces. But I did get it together. And do love it.