Hi guys, I wanted to make this PTFE tube connector, but printed it in TPU, because I noticed excessive wear on the tubes due to the stiffness of PLA, PETG, ABS, and other similar materials. To do this, however, I had to change the internal geometries so they could perfectly match the characteristics of the TPU. After several attempts, I found the right compromise between a soft grip and a strong seal.

Hi guys, I created this smartphone holder with the aim of creating a clean, stylized yet comfortable and practical shape. Besides being able to position your smartphone on your desk both horizontally and vertically, it can be attached to a wide variety of supports, such as kitchen accessories, chairs, playpens, cribs, kitchen cabinets, or any other surface you desire. To this end, I created four attachment sizes: Small 10mm, Medium 15mm, Large 20mm, and Extra Large 25mm. I hope you like it.

Hi guys, Christmas is here, and I wanted to create something out of the ordinary. I made this Santa Claus who, instead of riding reindeer, rides a shooting star. The goal is to make him sparkle and come to life on any Christmas lights. You can zoom him in as you like to adapt him to any function, for example: large, for a star on top of the tree; small, for a keychain or pendant; medium, for tree ornaments, etc.

“Smart Eyeglasses Case – Flexible, Sleek, and Ready to Go”

Hi guys, I have a question: How many times have you been annoyed by not being able to disconnect the hotend connector easily? Without having to pull the wires to preserve the hotend? Tired of that, I made this plug that can disconnect the connector with extreme ease. Just slide it from the back, push the lever on the back and at the same time extract. That's it. I hope it will be useful to you too and good printing to everyone.