Search models, users, collections, and posts
Bio
Computer Engineer looking to step into the maker world. Been looking at these since the RIPRAP
Achievements
Stellar Reviewer
Rate or Comment 275 different models
Pioneer Maker
Print successful 265 different models and 3,438 hours
MakerWorld Guardian
This badge has expired
legs are a pain to glue on
Share
0
0
0
too small for ours shoes
Share
0
0
0
works but difficult to line plates up in slots.
Share
0
0
0
P1S with Obsidian 0.4mm High flow. No brims, no failures
Share
0
0
0
Hour before our party starts and on my honey do list is to setup the tent. Being the "man" I am, I tried to do it myself and twisted up a leg of the tent and crack! CAD and Bambu Printer to the rescue.
The original screws should fit into the replacement part. You can also replace the original part with two (2) M5*20MM Button Heads (as pictured here) I would recommend stainless if you are planning on this part getting wet.
12 Foot Pop-Up Tent Lateral Hinge
17
50
Share
0
0
0
Share
0
0
0
No more data