very cute though I would like to see a version where the parts are separate by their colours and then assembled after for non ams printing

Printed it with Polyterra Cotton White. Printed really well except some overhangs were loose and could have used some support. The antlers are a little bit loose and I made a couple plugs to keep them in the skull. I'll upload the plugs the small holes for the antlers will need to be sanded a tiny bit but they're a friction fit into the antlers themselves and make it so they're not gonna fall out at the smallest snag. I would like to see the back half of the skull printed as one piece which would increase the strength quite a bit and would have no problem fitting on the A1/P1/X1/H2 build plates.