The only issue I have with this print is it wouldn’t run very well and the gears were crooked, but I found out how to fix it is I accidentally put in the bearings then the spacers on the main axles. I don’t know if it was an issue with the instructions or just a skill issue, but it was perfect after.

Worked perfectly, except for the instructions telling to recover the pin from the main gear, which didn’t fit the new main gear. There was an extra pin not used in the main card shuffler assembly, and it fit into the new main gear and worked perfectly, but it did cause me a lot of confusion.

The supports were a little hard to get off in some parts, mostly because the top and/or bottom was sticking to the main print. Most of the other supports just popped right off though! 9/10.