Awesome model! Printed great in gold PLA. Eyes are very tight, tapped them in with a hammer.

Nice! Works great with the screws and bearings. PETG on P1S

Fantastic! Everything went together great. All PLA on P1S. I had to print with supports!! There are a couple small overhang areas. It may be possible to print without but was easier for me to just add them.

Perfect! Spins great and printed no problem with the main profile. PLA+ on P1S

Couldn’t print the top without supports. May be user error but everything else prints fine. P1S / PLA+

Printed perfectly with settings on the profile. PLA+

Printed great without supports! Brown PLA

Printed great in PLA! I did the eyes and collar in the brown and just painted them. Everything snapped or glued in perfectly. I don’t know if it was an original print profile issue but I had a fail with the tail when selecting “remove small overhangs” in support settings. Recommend turning that off so the tail gets supported properly.

Printed great! Really wish there was a screw hole as a mounting option. Used a 3m square to mount.

Nice! Printed in PETG. Broke one of the small corners removing supports from the overhangs and super glued it. Be careful they are thin.

Came out great! Printed in PETG