CmdrMoto

liljohn406

**CHECK OUT V2 HERE** <a target="_blank" href="https://makerworld.com/en/models/185439#profileId-204181" rel="nofollow noopener">https://makerworld.com/en/models/185439#profileId-204181</a>**ALSO CHECK OUT MY RISER DRAWER SYSTEM HERE**  https://makerworld.com/en/models/185440#profileId-204184After many iterations I finally got something I am happy with. I used a led strip that is powered by USB and plugged it in the 5V plug behind the screen on my P1P/P1S. There are access holes on both sides to run cabling/led strip. Open pocket behind logo to stash some lights to illuminate it. Vents only on the sides with a sliding doors built in. Which are held down by the glass. Front logo is a seperate piece to save time and filament. Only two color changes this way opposed too many if it is part of the model. Picture was printed in Bambu Matte Black and Bambu Green. 3mf is set with slower outer walls to prevent bulging and poor overhangs at top of hexagons.

made it