Ended up not using this as I realized (as stated by some other users) the cana kit that came with the pi4 would not work. The power and HDMI cords come straight out of the side of the raspberry pi and there are no holes in the sides of this print for them. I tried to bend the cords around to come out under the board but there was no chance it would work without damaging the ports. The design is pretty solid otherwise, looks really great on the shelf.

Great print, going to put a few sticky feet on the bottom and it's perfect!

Incredibly well designed. The fit on this is PRECISION.

Prints well with pla silk. Center does spin on the default profile but I know there are updated versions that don't so use those if you care!

Wonderful orgainzer. The 6x3mm magnets are extremely satisfying when they snap together. This will make our next wingspan night so much easier to run!

Amazed at how well this printed in PETG. The fishies are gonna be stoked!

My sister used this to make some footprints for her daughter, christmas magic!

Uses a lot of filament but has SO MUCH STORAGE. Fits my whole collection of tools with room for more.

Beautiful print, however ran into some last layer issues where the taller sections of the back wobbled and ruined some of the scales. Make sure you have a very clean print plate and good adhesion for this one!

These sorting trays are the best! Works great for my watchmaking parts.

Beautiful little house for my 00 layout

Fun print! Looked really cool with silk/yellow! Make sure to print a lot at once, quite a few filament changes on this one.

Perfect for my HD660s, love this.

Incredible! Thank you so much for this, everyting is sturdy and the screw holes work perfectly with M4 12mm screws and washers/nuts.