Printed in PCTG and PET-CF, a little crunchy on the brush border for PET-CF at 0.12 layer height but usable, PCTG print came out a bit better. Got all the GCODE installed and running and my nozzle has never been this clean! Love it!

Quick easy print, printed in Bambu Basic PLA. Just a note to be careful bending them as the 'hinge' is pretty thin, so keep them flat until ready to install. Installed pretty easily, be sure to clip on hole portion first and give a tug back and be sure it's fully seated then snap the back down. Used 50mm PTFE cuts for 8 slots, working well so far but have been feeding a lot manually lately.

Andy sent me... :-P Needed an excuse to print something. Haven't installed it yet 'cause my battery is busy work'n but I'll probably toss it in there or give it to someone who can make use of it. Printed nicely & easily.