Kool Kid

DR3D_Prints

Here are some RC drift wheels. They have 12mm hexes and should fit just about every 1/10 scale on road or drift RC car. The wheel and tire are two separate models and print separately. Included is also an on road tire with grips so these wheels aren&#39;t just for drifting! If you print the on road tire with TPU they are surprisingly grippy. These wheels are also <a href="https://www.tiktok.com/@dr3d_prints/video/7345255219195809070" rel="nofollow">super durable.</a>Print them with supports and around 60% infill.If you like this model, we would really appreciate a like!

Star Spoke RC Drift Rims - Grip and Drift Tires

Arrma 3s BLX

19evdominta3

This is a corner connector/attachment piece for HSW storage. It allows you to “turn the corner”, i.e. connect 2 areas over a 90 degree angle. On the first HSW plate, it would use the first available hole, on the second HSW plate, it would use the second available hole. At least 2 is needed top/bottom (different orientations - or the same for consistency) to connect 2 plates together. 2 types are provided - those with a hole through the center and those without - see the pictures for the various types. In both cases there are plates for printing multiples at a time, 2x, 4x or 8x.&nbsp;There are other models on MakerWorld that requires glue and certainly has a nicer appearance - in my specific use I really wanted to have a connector hence this model was born.

HSW Corner Attachment

EngineerPro

Slightly over-engineered build plate holder with space for 4 staggered plates. Requires feet extension of the printer: <a target="_blank" href="https://makerworld.com/en/models/192730" rel="nofollow noopener">https://makerworld.com/en/models/192730</a>&nbsp;21 Feb 2024: Due to request, I added a experimental slim version that is 18 mm tall and with different internal diameter (30.2 mm) of the “loops” to fit Bambu Labs Anti-Vibration Feet. It is reported to work well, just be carefull when assembling the three parts to not break any tabs.&nbsp;

Build Plate Rack storage under X1/P1 printer

Printer Stuff

cruse2382

please make sure you bed is clean before printing as silhouettes will be slightly harder to print because of the thin lines&nbsp;all car silhouettes are available in this collection <a target="_blank" href="https://makerworld.com/@cruse2382/collections/135486" rel="nofollow noopener">https://makerworld.com/@cruse2382/collections/135486</a>&nbsp;this one has a few thin bits so probably wont print too well much smaller.

Arrma 3s BLX

HSW

Printer Stuff

Cars