A simple, yet enjoyable figure! One of the issues I have is that the waist swivel is too loose. In addition, I think it would be better for the feet to have additional articulation.

The case seems secure, but I would suggest to make the latch connections a bit more tighter.

The good news is that the parts printed without any issues and the guitar stand is foldable. The bad news is that the key won’t insert to the halves, most likely because the circular tab is a little bigger than the hole from the key.

Good print for me, but my main issue is that some of the joints like the elbows and knees are loose for each figure.

I printed in petg; the ratchet seems fairly strong!

Based on the test print, the bridging performs well at around 10 and begins to sag at around 20

The print came out great! My only issue is that the peg doesn’t fit, so I had to sand it to make it more circular.

The print came out smoothly! I’m plannning to use it’s mechanism as a reference for a design I had in mind.

I used this to loosen the yellow crabs joints. Overall, I highly recommend printing this set for Kamen rider Hibiki fans! I’m not sure if I will do the others as I do not have the right colors…

The small claw unfortunately got too loose when loosening the joints, but overall, the print came out with minimal problems. Out of the other disk animals in this set, the yellow crab’s transformation is a little complex and will require the tool to loosen the legs and eyes.

Overall, the transformation was straightforward, and the model is solid!

Simple transformation, and a solid replication of the blue wolf. My only issue is that the tail is too loose after printing…

A little difficult to insert the parts, but I managed to get them to fit!

Overall build feels great and flexible just like the original Dummy 13

It’s smaller and a littler thicker than I thought. The joints were tight at first, but I was able to loosen them by hand. Overall, I love this print as a fan of the Disk Animals. I printed this in PLA, but I just printed it in red and silver as I do not have black PLA, so I colored the black sections with a marker. I might print the other Disk Animals soon…

A great display stand for the Dummy 13! I originally printed one in PLA; it did get loose after a few days, so I used a few coats of superglue to tighten the joints.

I originally got the files from Printables; I reprinted the frame with petg black after the blue Petg HF became loose. The accessories are great, but I find that the cap is loose on mine. I printed the display stand in PLA; it just got a little loose after a few days

A great improvement from the Lucky 13! A minor issue that I have is that the toes are a little hard to connect to the feet.