This was a challenging, but satisfying print. First up, be sure to tune your filaments for overhangs. The cape is pretty demanding. Using adaptive layer height might help a bit with the overhangs. It wasn't bad enough for me to worry about reprinting it. Tolerances are definitely tight for some bits, a little loose for others. The fangs were difficult for me to insert. If I were to change anything, it would be to just go with embedding the fangs in the model like the rest of the colored teeth. It'll need support, but if you're already printing with an AMS, might as well include the fangs. Perhaps a separate print profile or plate just for that could be an option. Printed on a P1S with AMS.

Shrank it down and added a wall loop to reinforce the ears. Makes a nice little piece.

Prints were successful, though I feel the model could use a bit of reinforcement at the thin part of the blade. Printed in translucent PETG with elemental blade designs in mind.