Printed in PETG- had a little warp on the bottom of the side pieces so sanded them in the middle (which was higher) and then sliced a 1.75mm piece to fit between them so the connector plates fit correctly. Looks great. Thanks!

Great print. Made a base from another version I found. Used less infill on the boots and then drilled them out to fill with sand before I glued together. Same for the base- added a hatch to put sand in behind the feet and used spiral so I could get sand further around the outer 1/3 since the center I added a 75% infill modifier for the boots to sit on to be solid. Most difficult part is removing supports from the head around the eyes, etc. Used Elegoo PETG for the most of it with some other brands mixed in for certain colors. Just over 3' tall.