Prints great, printed in HIPS, so I could use model glue to glue minis to it. changed z height to 4 mm to match Games Workshop base heights

wish I could rate 6 stars

some layer adhesion issues with a fresh roll of petg. most likely an issue on my end

amazing in ABS just wish I picked a colour other than white lol

printed great in pla, warped while I was printing abs due to ambient heat. going to re print in abs or asa

printing so many of these for all my colours

some stringing but still very useable

used them for my spool holder l, no issues

slightly difficult to get on but work amazing

perfect settings, easy to remove supports

printed flawlessly