The thin white layer sandwiched in the middle to keep all the stripes together is a very nice solution. It printed and bent as expected. Thank you.

Scaled to 140%, and added a negative rectangular space to fit the bar magnet I had which was 40x10x5 mm. I suspended that negative space a few layers above the bottom and added a pause in the print. This way it’s impossible for the magnet to fall out; safer for pets and kids. This multicolor print worked great on an A1 mini. No support needed and no prime tower just like indicated in the two color print profile supplied by the designer.

Great design. Bar will need a curve in some cases (like mine). Otherwise, the bar rubs against the inside of wall of the tank. Not a big deal. User needs to press the handle back down after each use. Minor issue; great design. I printed in PETG just to be sure it would survive the damp environment.