printed nicely. However it’s bigger than I thought. And the supports for the lid were a little difficult to get off. But once you start an area the supports come off as one piece

prints really well and the hinges connect easily. however, don’t try to print multiple set of hinges at the me time because Bambu Handy treats the hinges as separate parts and pits the two part hung on the build plate separately, which makes them useless

printed really well and is very useful for my sunflower seeds

printed really well. My son loves it

it’s a great print

just started

yet another well designed model

prints great, however the connector used to align the parts together break up if you look at them in a funny way. they need to be made of sold filament not empty squares

this is a great model, fits together well and prints really nicely

good quality model. printed well

printed well

Another GREAT print. All the parts fit together well, but the black and silver part are hard to fit together and so is the front vent made of silver and white. Like R2D2 don’t over tighten any of the bolts. had to print two Antenna twice because the first one was to tight. I used a blade on the inside bottom of the hole and the second one fit when pushed in

another great print. I had difficulty pushing the sliver part of the head through the many small holes. also I can put the white top part of the head on, but when I screw in the top bolt the tread pulls up the top. not sure what to do. also one side panel will just not stay in. but overall a great print

This has been the MOST difficult print in my 6 years of 3d printing. The black parts print with no issues. I attempted to print the wings and body and it failed due to poor adhesion of the supports. I separated the body from the wings and printed separately. Had to print the body 4 more times before getting a print where the supports didn’t come off the build plate. I printed the wings three times before I could get both wing. as each wing takes 8hr to printed I have put in over 60hr. I have no issues with this build plate with any other model.

nice model but hard to put together. There are several push fit connectors and 80% of them broke off while I was pushing them into place. also the front and the main body do not have enough infill so don’t print from the Handy app print using your own setting in the Studio program. The front part and main body seem to be made from two parts, but for some reason weren’t stuck together and broke in two when I took them off the build plate

printed well. just printed the 81mm version with the dandy top. printed nicely and works well

I am in aw of your modeling skills. all the parts printed perfectly and all fit together perfectly. this is a brilliant model. Ppoints to note: don’t over tighten the screws/bolds they have a habit of snapping. the front grill that is white and silver was had to put together (see photo and because of this sticks out a little. I don’t have a solution for this

just started printing