Came out beautiful for a memorial piece for my lady. Thank you so much.

Came out beautiful for a memorial piece for my lady. Thank you so much.

Came out great and looks amazing on this this custom headband!!!

This turned out awesome. I didn't like the way the weathering was turning out and I was like helmets get dirty because of hands touching them. So just put the marker all over my hand and touched it and it worked out pretty good! For the visor, I used a piece of paper to trace the inside of the helmet where to cut, then laid it over the plastic face shield I bought and used a pair of decent scissors to cut thru the plastic. I'm still not sure of what to use to hold the visor inside, might try velcro, but once my head is in it holds well. Also trying to figure out a way to make breathing easier. I'd hate to put holes in the visor, but I might have to. My nose is a bit too big so it is also smooshed up against the visor Recommend printing probably 102% or so if you have a longer nose. I used Geeetech Silk PLA Metallic Silver set as Bambu Silk in settings on the Smooth PEI plate with some stick glue covering the entire plate. Amazon Link to the visor: https://a.co/d/8FWxA0U

Turned out pretty well. I edited it in BambuStudio and turned it on it's back, as I got some warped lines going as tall as it does. Next 3 prints while on it's back turned out much better. There's some scruff on the bottom of the Doom one because I tried to see how well it would print on Sport setting on X1C, and it did not print well, lol, so I changed it after that point in the print back to Standard.

Worked perfectly for my miniature bubble bath. I resized a single ducky very tiny. I was honestly shocked it printed this small without issue! Thank you!

I initially tried to print it on the textured plate but it kept coming up on the bottom left corner, even after washing it thoroughly with dish soap and letting the plate dry. So I switched to the SuperTack plate and had no issues. Looks great!

This came out wonderfully and my birdies love it! I used dark brown for the top then weathered it with acrylic paint pens (blue, red, white, grey, black) by going around it with a color, then wiping it with isopropyl alcohol and repeating. I changed the windmill piece to print outer/inner walls instead of the default because my first windmill broke trying to get it in the hole on the top piece. Overture Rock PLA used for the bottom. Here's a video of my birdies!: https://streamable.com/hnwtte

I dont know anything about Axolotl's but my nephew does and he loves these!

Changed to 0.16mm layer height to get a better quality print. Looks great! Thank you!