Alison_mackel

Kit Crafters

&nbsp;Print out this automata kit to assemble your very own infinitely looping marble run!&nbsp;This automata converts rotational energy into vertical energy that uses gravity to push marbles up! The entire model doesn't need supports and is very easy to print. It's been tested and developed with Bambu PLA Basic/Matte and Sunlu PLA+. The marbles used are 10mm ball bearings (the same as Hextraction). The profile also includes some marbles that you can print (already set to 100% infill for the marbles only).&nbsp;Here's a render of how the automata kit is put together:<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/143317/2023-11-03_6ae80076ff3b8.png"></figure>The cams (tear drop shaped parts) have an arrow to show which way you turn them to twist-and-lock them onto the main axle. The cams should alternate the direction the arrows on them are facing to match up with the render above. Take a look below:<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/143317/2023-11-03_2a7a70095305b.png"></figure><figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/143317/2023-11-03_7ca5be748f5e6.png"></figure>&nbsp;Enjoy the automata and let me know if you have any ideas for new ones!

Mini Marble Run - Automata Kit

fidgets

TheCreativeLily

Keyring in the style of Mickey Mouse's hand doing the ‘Rock’/Devil Horns hand gesture.

Mickey Mouse Devil Horns Keyring

print for personal

mcgybeer

Articulated Lizard, the original!No supports or assembly required. Just slice and print!!

Articulated Lizard v2

animals

JamesThePrinter

A selection of Halloween ghosts that use LED tea lights to glow.Short Models (100mm Tall)<ul><li>Scary Ghost</li><li>Spooky Ghost</li><li>Happy Ghost</li><li>Blank Ghost - Design your own face! (.f3d and .stl included)</li></ul>Large Models (150mm Tall)<ul><li>Scary Ghost</li><li>Spooky Ghost</li><li>Blank Ghost - Design your own face! (.f3d and .stl included)</li></ul><figure class="image image_resized image-style-align-center" style="width:50%;"><img src="https://makerworld.bblmw.com/makerworld/draft/70395/2023-09-12_nh65u2uq6cpe.gif"></figure>Most tea lights have a 38mm (1.5in) diameter. The openings in these models are slightly oversized, so most (if not all) tea lights will fit. Just turn on the LED and set your ghost on top. If you are worried about getting lights that fit, <a target="_blank" href="https://amzn.to/3YQGEA9" rel="nofollow noopener">these</a> are the tea lights that I used.&nbsp;Check out my other holiday models <a target="_blank" href="https://makerworld.com/en/u/1360890085/collections/23941" rel="nofollow noopener">here</a>.&nbsp;Print SettingsThese have all been designed to print with 2 perimeters and require no infill. Some overhangs in the mouth and eyes require good cooling.&nbsp;<a target="_blank" href="https://www.buymeacoffee.com/JamesThePrinter" rel="nofollow noopener">Buy Me A Coffee</a>&nbsp;The following filaments were used in the pictures above:<ul><li>Sunlu PLA White</li></ul>

fidgets

print for personal

animals

halloween