DonutDaCat

Legacy Metroplex: Better Elbows

Toblerone Shaped Fidget

Gundam RG RX-78-2 2.0 Display Stand

congee prints

Devastation Nemesis Figure

0.12mm layer, 2 walls, 8% infill

Very nice model. Much cheaper than the actual upgrade kit while still looking just as good. Printed mine it PETG to insure long-lasting durability.
***MY TIPS TO PRINT*** Add a raft for the shoulders since the limited area of their bottom faces make adhesion a nightmare, especially with PETG. If you don’t want to deal with super glue in the event that you want to remove the shin plates, scratch the backs of the shin plates with a blade to add texture then use hot glue against the tubed texture on the figures shins (the textures will help the hot glue stick and keep the plate bonded to the figure while still being to remove it in the future with some force but no residue). Use the “print by object” setting and group the pieces by identical pairs.

Atlas pax

upgrade kit for legacy united Vector Prime

LEGACY VECTOR PRIME UPGRADE KIT 

Charger fit perfectly. The cable had to twist at a weird angle though so it doesn’t quite lay flat. A little tape fixed the problem.

Pulsar Designs

Charging Stand for Apple Watch

0.2mm layer, 2 walls, 15% infill

Very nice, will there be a 3-digit in the future?

Mirran.Workshop

Life Counter - Single spinner

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian