PattersonPrints

Pencil-Die

Keychain Quick-Release Buckle + Shopping Cart Coin

Flapping Pterodactyl

Screw Eye Socket Attachment

Drive-In Descending Distance Determinator

good print. put a gloss coat over it to reduce microplastics touching stuff that goes inside me, but a much needed piece for my bathroom

3D Dog

Stylish Cotton Pad, Floss Stick and QTIP Holder

0.18mm layer, 2 walls, 15% infill

EDITED: Had an issue with cantilevers, but that seemed to be a PEBKAC problem. ignore the broken loop, it was added post processing to make it into a necklace charm and was too thin so it broke quickly.

nfocus design

Slice of pepperoni pizza

0.2mm layer, 2 walls, 15% infill

Fix3D

Glove clips Handschuhe Firefighter Work garden Garten Print in Place Klammer infinite clamp

0.2mm layer, 4 walls, 15% infill

edit: took some time to loosen up, but it does seem to transform fine after a few days of use thanks to PLA creep

original rating: I really like your entire series and had a great time with assassanana, but this one really did not want to cooperate. I couldn’t get it to close, couldn’t get it assembled, couldn’t get it to stand. after some time for the PLA to loosen, it got a little easier, but I think I might still be crazy cos it takes a lot of messing about to get it to stand proper.

Dr Operator

G1 Docobot: Cherry Bomb

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian