looks great

looked great!

I like the design on top, so I used it on a phone stand.

printed great with no issues! I printed one in PLA Basic & in PLA Silk+. The shiner Silk+ shows layer lines at the top but very acceptable.

printed great with no issues! I printed one in PLA Basic & in PLA Silk+. The shiner Silk+ shows layer lines at the top but very acceptable.

Easy print with no issues

if the model had a “peg & hole” to align the 2 halves for assembly, it would get 5 stars 🌟

Easy to customize with everyone’s favorite colors. I had several issues with painting the skinny strip in the center on the left & right edges. For some reason, one of the strips wouldn’t stay painted with the color I used. Any help will be greatly appreciated.

excellent model. my only suggestion is to make the support inside the mouth easier to remove, (if possible)

I like this one a lot!!

the supports were especially hard to remove from underneath the chin. The wing on one model broke off while removing the supports.

you have to be careful when removing supports because it can be hard to tell the difference between supports and “drips” (part of the design)

looks exactly like the picture 👍🏼

smaller than I expected but I’m sure it can be made bigger without issues

looks great! printed in PETG-Translucent

good designs