The print quality and design is very nice! The print profile worked very well too. The only thing I can think needs a little improvement would be the part tolerances are a tiny bit loose, at least for PETG. It was sometimes difficult to keep things together when working on the next step of assembly. PLA may work better so it could be the material I used.

It turned out really well! I used a 0.2mm nozzle with PETG. I plan to spray it with clear polyurethane sealant to fill the layer lines.

The soap container fits perfectly!

It turned out great!

Works great! I used a #8 finishing head screw and it holds up the hat very well.

Works great! The center pin is a snug fit but it’s a very nice top once assembled!

They fit just right! They make mounting them super easy.

It turned out amazingly! I did not have white so I used a light grey and it still looks great, just not as bright.

It’s a great bookmarker! To only have one filament change, I swapped the paw at the bottom over to a negative space which still turned out very nice!

The tolerance is just right to slide easily over the light! Printed in yellow so it’s easier to see against the black light. It will be printed in black ASA when installed outside.

It turned out flawless on the first try!

so adorable and turned out great!

I could not have asked for a better looking print!

These turned out better than I expected! They fit in the shoes perfectly too!

What a fantastic model! I used a generic orange PLA and it turned out as good as anything!

It fits Taco Bell as well as other ketchup, mustard, etc. packets very well!