it’s hard with PLA to make a well preforming guitar pick. despite that this makes a great decoration and emmergency pick

for what it is supposed to be, really good. me personally I didn’t like that if you put the slightest pressure on it that it would sink down and hit the bottom, making it hard to fidget. I just took of the bottom piece and only used the top and that was more enjoyable.

hahaha! came out spectacular. I was worried that the print might come out choppy, but it was actually SO smoothe. great print!

When slicing it recomended supports, so I applied them. When it was done printing the supports were practically impossible to remove. After finally removing them you had to aggressively break the small pieces inside that were constricting the cubes motion. After finally breaking it in, it came out really well. All in all a great print!! I also shrunk the cube when I was making it because I didn’t want it the full size, this may have been the reason I had so many difficulties.

very good print. supports slightly hard to remove